until the
end of the lecture period. Teaching will be provided via digital courses. This applies to all
types of courses, e.g. also in the area of further education.
2. Attendance events in
Struggle? We don´t let you down!
Stephan Bach
Bridge courses and undergraduate studies
Tutorials and Support
Mathematics Refresher Course (before the start of the summer semester) |
Stephan Bach
Berufliche Fachrichtung Elektro- und Informationstechnik
page
Modulhandbuch
Course Catalogue
Ingenieurpädagogik – berufliche Fachrichtung
Elektro- und Informationstechnik [...] Medien und Informatik
Seite 7 von 81
Inhalte der Lehrveranstaltungen
Course Content
Aussagen, Mengen, Zahlenmengen;
Reelle Folgen und Funktionen;
Differenzialrechnung; [...] zur Stoffnachbereitung und Prüfungsvorbereitung optimieren.
Inhalte der Lehrveranstaltungen
Course Content
Grundlagen der Elektrotechnik: Elektrische Größen, Grundschaltungen, elektrische Energie
of reaction is
used, this type of cantilever turbine can be applied using partial admission. Of course, this benefit
does have a disadvantage: the cantilever „quasi-impulse“ turbine requires a slightly
Thus, the losses are smaller and the efficiency is higher than in an axial impulse
turbine. Of course, this benefit does have a disadvantage: the cantilever „quasi-impulse“ turbine
requires a slightly
preparation of e-portfo-
lios (in advance to the course), ii) the design of individual e-portfolios (during the course)
and iii) the evaluation at the end of the course.
The main findings of this work are [...] existing course on project-based product
design, changes to the course have to be made. These are detailed in the following sections.
2.1 Content and organizational changes to the course
The course [...] existing course on product design. Section 2.2
will explain, how the students are introduced to the use of e-portfolios. Section 3 describes
the evaluation of the changes implemented in the course and provides
Participation in the Mahara course will be a prerequisite for registering for our product design course.
page
EPDE2022/1190
The instructor of the course could also imagine a more extensively [...] a product design course that is geared towards
practical work. At our university, we have started to explore how to implement e-portfolios with the
software Mahara in a course on project-based [...] to really work with Mahara, a short course (with a workload of 3 hours) on Moodle
that they can go through by themselves is a good additional resource. The course contains different tasks
that,
improvements to the course (Section 4).
2. THE COURSE ON "PROJECT-BASED PRODUCT DESIGN"
The course on project-based product design for bachelor students is a mandatory course
in the 6th term of [...] product design course, which is a mandatory
course in the 6th term of the bachelor program on Sustainable Engineering at the
University of Applied Sciences Ansbach (Germany). The course allows students [...] Structure and implementation of the course
The course includes two 90-minute slots in the weekly curriculum over 14 weeks during
each summer semester. The course is structured in two main parts, each
PDFContext
pdf:docinfo:created 2024-05-13T11:15:13Z
page
Modulhandbuch
Course Catalogue
Ingenieurpädagogik – berufliche Fachrichtung
Elektro- und Informationstechnik (EI) [...] und ggf. auch einen Hinweis auf ein Bonussystem führen
Inhalte der Lehrveranstaltungen
Course Content
Aussagen, Mengen, Zahlenmengen;
Reelle Folgen und Funktionen;
Differenzialrechnung; [...] zur Stoffnachbereitung und Prüfungsvorbereitung optimieren.
Inhalte der Lehrveranstaltungen
Course Content
Grundlagen der Elektrotechnik: Elektrische Größen, Grundschaltungen, elektrische Energie
Microsoft Word - 2022_07_20_Modulhandbuch_IPE.docx
page
Modulhandbuch
Course Catalogue
Ingenieurpädagogik – berufliche Fachrichtung
Elektro- und Informationstechnik (EI) [...] und ggf. auch einen Hinweis auf ein Bonussystem führen
Inhalte der Lehrveranstaltungen
Course Content
Aussagen, Mengen, Zahlenmengen;
Reelle Folgen und Funktionen;
Differenzialrechnung; [...] zur Stoffnachbereitung und Prüfungsvorbereitung optimieren.
Inhalte der Lehrveranstaltungen
Course Content
Grundlagen der Elektrotechnik: Elektrische Größen, Grundschaltungen, elektrische Energie
vhb.org/studierende/registrierung/
annotation https://moodle.oth-aw.de/course/view.php?id=1106 https://moodle.oth-aw.de/course/view.php?id=1106
LD_Deckblatt_WS24-25.pdf
Wichtige Informationen:
one pressure gauge on the wall determined for the
static pressure measuring. In CFD there are of course
many ways how to evaluate certain variables - an area
or a mass flow weighted average, simple average
function of rotational speed
The higher the mass flow rate (inlet pressure), the smoother the course because measurement
accuracy is increased, interferences are getting relatively smaller. At inlet [...] turbine inlet
pressure varies, outlet pressure is almost constant)
The curves show very similar courses with exception of ncorr: 92% and 96%. This different
shape is just caused by the data points at
function of rotational speed
The higher the mass flow rate (inlet pressure), the smoother the course because measurement
accuracy is increased, interferences are getting relatively smaller. At inlet [...] turbine inlet
pressure varies, outlet pressure is almost constant)
The curves show very similar courses with exception of ncorr: 92% and 96%. This different
shape is just caused by the data points at
speed for
maximum efficiency varies slightly between 23,000 rpm and 24,000 rpm. However, the course for the lowest
pressure ratio (PR = 12.6) is not reasonable. The measured points at 22,000 rpm [...] pressures. Hence, 1D-design efficiency calculations with measured turbine
inlet data confirms the courses of the measured efficiency curves. However, relative deviation from ideal gas
is only half of [...] points more efficient than
their competitors in the comparable power class of around 10 kW. Of course, turbines pressure ratios must
be taken into account, which is significantly lower for Kaczmarczyk´s
Virtuelle Hochschule Bayern an.
Derzeit wird das Thema über das Stichwort MOOC (massive open online
courses) intensiv diskutiert.
page
Viele Fragen sind noch offen: Erbringen von Prüfungsleistungen
for this course?
(1) Very high (2) High (3) Average (4) Low (5) Very low
Q3 How many hours per week did you have to invest on average in self-study and
homework in addition to the courses?
(1) More [...] basics course prior to the start of the semester (intensive days).
The strongest support is most evidently achieved through the provision of sample exams
(Q507). A preparatory math basics course prior [...] Bachelor has been adapted so that difficult courses in the first two
semesters have been thinned out and moved to higher semesters, e.g., the programming
course. Sixthly, there were also changes within
identical for an axial impulse, an axial Curtis and the radial inflow cantilever
turbine. Of course, the static enthalpy drop due to the centrifugal pressure field is taken into account for
the
of reaction is
used, this type of cantilever turbine can be applied using partial admission. Of course, this benefit
does have a disadvantage: the cantilever „quasi-impulse“ turbine requires a slightly
bundle is also commonly used in the ORC application.
The development of these heat exchangers of course has its difficulties, for example the selection of the tube material,
the calculation of the [...] the CAD file, where the length of the tube bundles and the shells are
automatically adapted. Of course all of the connecting dimensions regarding the headpieces and flanges also need to
be adapted [...] is required. An
alternative version of the headpiece, which would only consist of one piece of course also has some advantages e.g. a
reduced number of parts, a reduction of potential assembling
bundle is also commonly used in the ORC application.
The development of these heat exchangers of course has its difficulties, for example the selection of the tube material,
the calculation of the [...] the CAD file, where the length of the tube bundles and the shells are
automatically adapted. Of course all of the connecting dimensions regarding the headpieces and flanges also need to
be adapted [...] is required. An
alternative version of the headpiece, which would only consist of one piece of course also has some advantages e.g. a
reduced number of parts, a reduction of potential assembling
Thus, the losses are smaller and the efficiency is higher than in an axial impulse
turbine. Of course, this benefit does have a disadvantage: the cantilever „quasi-impulse“ turbine
requires a slightly
Praxisbegleitende Lehrveranstaltung: Betriebswirtschaftl.Grundlagen
Modulbezeichnung englisch Course accompanying practical semester: Business Management
Kreditpunkte (ECTS) / SWS 5 CP / 0 SWS [...] Projekt
Modulbezeichnung deutsch Studiengangspezifisches Projekt
Modulbezeichnung englisch Course Specific Project
Kreditpunkte (ECTS) / SWS 5 CP / 0 SWS
Häufigkeit des Angebots jährlich [...] Modulbezeichnung deutsch Studiengangspezifische Wahlpflichtmodule
Modulbezeichnung englisch Course Specific Compulsory Optional Subjects
Kreditpunkte (ECTS) / SWS Summe 10 CP / 8 SWS
Leh
T05:44:43Z
page
Modulhandbuch
Course Catalogue
Patentingenieurwesen (PI)
Patent Engineering
[...] Maschinenbau/Umwelttechnik
Seite 9 von 115
Inhalte der Lehrveranstaltungen
Course Content
Gleichungen und Ungleichungen, lineare Gleichungssysteme, Matrizen und Determinanten, [...] systematisches Arbeiten in Übungsgruppen bzw. im Eigenstudium.
Inhalte der Lehrveranstaltungen
Course Content
Differentialrechnung in einer und mehreren Veränderlichen sowie Integralrechnung in einer
der Fachhochschule Amberg-Weiden
page
Modulhandbuch
Course Catalogue
Patentingenieurwesen (PI)
Patent Engineering
[...] systematisches Arbeiten in Übungsgruppen bzw. im Eigenstudium
Inhalte der Lehrveranstaltungen
Course Content
Gleichungen und Ungleichungen, lineare Gleichungssysteme, Matrizen und Determinanten [...] systematisches Arbeiten in Übungsgruppen bzw. im Eigenstudium.
Inhalte der Lehrveranstaltungen
Course Content
Infinitesimalrechnung im Reellen: Differenzialrechnung in einer und mehreren Variablen