function of rotational speed
The higher the mass flow rate (inlet pressure), the smoother the course because measurement
accuracy is increased, interferences are getting relatively smaller. At inlet [...] turbine inlet
pressure varies, outlet pressure is almost constant)
The curves show very similar courses with exception of ncorr: 92% and 96%. This different
shape is just caused by the data points at
speed for
maximum efficiency varies slightly between 23,000 rpm and 24,000 rpm. However, the course for the lowest
pressure ratio (PR = 12.6) is not reasonable. The measured points at 22,000 rpm [...] pressures. Hence, 1D-design efficiency calculations with measured turbine
inlet data confirms the courses of the measured efficiency curves. However, relative deviation from ideal gas
is only half of [...] points more efficient than
their competitors in the comparable power class of around 10 kW. Of course, turbines pressure ratios must
be taken into account, which is significantly lower for Kaczmarczyk´s
Modulhandbuch_v0.7_2021.01.04.docx
page
1
Inhalt
Modulhandbuch
Course Catalogue
Bachelor
Künstliche Intelligenz (BKI)
Artificial Intelligence
Künstliche [...] Mathematics 🇬🇧 .......................................................... 11
Intensive Language Course (German/English) 🇬🇧 ........................................ 13
International & Intercultural [...] einfache Roboter-Interaktionssysteme entwerfen und realisieren.
Inhalte der Lehrveranstaltungen
Course Content
Informationsverarbeitung & Sensoren der Robotik
Roboterhardware & Interaktionshardware
beruflichen Umfeld
Inhalte der Lehrveranstaltungen
Course Content
63 / 113
page
Inhalte der Lehrveranstaltungen
Course Content
* Präsentation von Praxisberichtinhalten [...] Methoden der Logik und Deduktionssysteme sowie des Semantic Web.
Inhalte der Lehrveranstaltungen
Course Content
Grundlagen der Logik (Aussagenlogik & Prolog)
Grundlagen des Semantic Web (Unicode, XML [...] und lösen.
9 / 113
page
Inhalte der Lehrveranstaltungen
Course Content
• Grundlagen des Programmierens
• Syntax, Datentypen, Variablen, Ausdrücke, Datenstrukturen
der Fachhochschule Amberg-Weiden
page
Modulhandbuch
Course Catalogue
Patentingenieurwesen (PI)
Patent Engineering
[...] systematisches Arbeiten in Übungsgruppen bzw. im Eigenstudium
Inhalte der Lehrveranstaltungen
Course Content
Gleichungen und Ungleichungen, lineare Gleichungssysteme, Matrizen und Determinanten [...] systematisches Arbeiten in Übungsgruppen bzw. im Eigenstudium.
Inhalte der Lehrveranstaltungen
Course Content
Infinitesimalrechnung im Reellen: Differenzialrechnung in einer und mehreren Variablen
function of rotational speed
The higher the mass flow rate (inlet pressure), the smoother the course because measurement
accuracy is increased, interferences are getting relatively smaller. At inlet [...] turbine inlet
pressure varies, outlet pressure is almost constant)
The curves show very similar courses with exception of ncorr: 92% and 96%. This different
shape is just caused by the data points at
Anna; Babenko, Kristina (2021). Step-by-step Solution of Applied Engineering Problems in
Mathematics Courses Using STACK. International Meeting of the STACK Community 2021. Zenodo.
Analysing the questionnaire [...] According to positive feedback, the outlined approach will be extended to the other mathematics courses.
2) The practice has shown mutual benefit from the active involvement of students (future teachers
Virtuelle Hochschule Bayern an.
Derzeit wird das Thema über das Stichwort MOOC (massive open online
courses) intensiv diskutiert.
page
Viele Fragen sind noch offen: Erbringen von Prüfungsleistungen
identical for an axial impulse, an axial Curtis and the radial inflow cantilever
turbine. Of course, the static enthalpy drop due to the centrifugal pressure field is taken into account for
the
bundle is also commonly used in the ORC application.
The development of these heat exchangers of course has its difficulties, for example the selection of the tube material,
the calculation of the [...] the CAD file, where the length of the tube bundles and the shells are
automatically adapted. Of course all of the connecting dimensions regarding the headpieces and flanges also need to
be adapted [...] is required. An
alternative version of the headpiece, which would only consist of one piece of course also has some advantages e.g. a
reduced number of parts, a reduction of potential assembling
bundle is also commonly used in the ORC application.
The development of these heat exchangers of course has its difficulties, for example the selection of the tube material,
the calculation of the [...] the CAD file, where the length of the tube bundles and the shells are
automatically adapted. Of course all of the connecting dimensions regarding the headpieces and flanges also need to
be adapted [...] is required. An
alternative version of the headpiece, which would only consist of one piece of course also has some advantages e.g. a
reduced number of parts, a reduction of potential assembling
preparation of e-portfo-
lios (in advance to the course), ii) the design of individual e-portfolios (during the course)
and iii) the evaluation at the end of the course.
The main findings of this work are [...] existing course on project-based product
design, changes to the course have to be made. These are detailed in the following sections.
2.1 Content and organizational changes to the course
The course [...] existing course on product design. Section 2.2
will explain, how the students are introduced to the use of e-portfolios. Section 3 describes
the evaluation of the changes implemented in the course and provides
Participation in the Mahara course will be a prerequisite for registering for our product design course.
page
EPDE2022/1190
The instructor of the course could also imagine a more extensively [...] a product design course that is geared towards
practical work. At our university, we have started to explore how to implement e-portfolios with the
software Mahara in a course on project-based [...] to really work with Mahara, a short course (with a workload of 3 hours) on Moodle
that they can go through by themselves is a good additional resource. The course contains different tasks
that,
improvements to the course (Section 4).
2. THE COURSE ON "PROJECT-BASED PRODUCT DESIGN"
The course on project-based product design for bachelor students is a mandatory course
in the 6th term of [...] product design course, which is a mandatory
course in the 6th term of the bachelor program on Sustainable Engineering at the
University of Applied Sciences Ansbach (Germany). The course allows students [...] Structure and implementation of the course
The course includes two 90-minute slots in the weekly curriculum over 14 weeks during
each summer semester. The course is structured in two main parts, each
University of
Applied Sciences Amberg-Weiden (OTH) in Weiden, Germany. Students are required in the course of their studies to complete a
minimum 20-week practical internship, preferably abroad. Students [...] variety of departments.
By the time students begin their internship, they have usually had course work in the following areas (not an exhaustive list):
• Economic Geography and Macroeconomics [...] full semesters are required for the second
foreign language)
Due to the sheer variety of courses required in this BA programme, firms may place students in one of many areas - which from an
operational
2022-01-27T09:11:49Z
TM_Alt_SoSe22MHB
page
Modulhandbuch
Course Catalogue
Internationales Technologiemanagement (TM)
International Technology Management [...] und effektiv zu kommunizieren.
(Kommunikationskompetenz)
Inhalte der Lehrveranstaltungen
Course Content
Grundlegende Einführung in die Themengebiete:
• Produktentstehungsprozess (PEP)
• Grundlagen [...] Bauelemente in einfachen Schaltungen erfassen und bewerten.
Inhalte der Lehrveranstaltungen
Course Content
• Grundlagen der Elektrotechnik und der Energietechnik.
• Grundlagen der Halbleitertechnik
date 2013-04-03T05:55:07Z
pdf:PDFVersion 1.3
xmp:CreatorTool PScript5.dll Version 5.2
pdf:docinfo:title Microsoft Word - Modulhandbuch-ES-2013-SS.doc
stream_content_type application/p
Microsoft Word - 2022_07_20_Modulhandbuch_IPE.docx
page
Modulhandbuch
Course Catalogue
Ingenieurpädagogik – berufliche Fachrichtung
Elektro- und Informationstechnik (EI) [...] und ggf. auch einen Hinweis auf ein Bonussystem führen
Inhalte der Lehrveranstaltungen
Course Content
Aussagen, Mengen, Zahlenmengen;
Reelle Folgen und Funktionen;
Differenzialrechnung; [...] zur Stoffnachbereitung und Prüfungsvorbereitung optimieren.
Inhalte der Lehrveranstaltungen
Course Content
Grundlagen der Elektrotechnik: Elektrische Größen, Grundschaltungen, elektrische Energie
Berufliche Fachrichtung Elektro- und Informationstechnik
page
Modulhandbuch
Course Catalogue
Ingenieurpädagogik – berufliche Fachrichtung
Elektro- und Informationstechnik [...] Medien und Informatik
Seite 7 von 81
Inhalte der Lehrveranstaltungen
Course Content
Aussagen, Mengen, Zahlenmengen;
Reelle Folgen und Funktionen;
Differenzialrechnung; [...] zur Stoffnachbereitung und Prüfungsvorbereitung optimieren.
Inhalte der Lehrveranstaltungen
Course Content
Grundlagen der Elektrotechnik: Elektrische Größen, Grundschaltungen, elektrische Energie
page
OTH Amberg-Weiden - Digital Technology and Management - Prof. Dr. Julia Heigl
1Course of Study
02
IoT Technology
Product
Management
Sensors for Smart
Systems
Communication
Technology
page
Anlage 3
4.3 Programme Details See “Transcript of Records” for list of courses and grades; and
“Prüfungszeugnis” (final Examination Certificate) for subjects offered in final [...] www.oth-aw.de
On the programme: http://www.oth-aw.de/studium.html
For national information courses c.f.8.8
7. Certification This Diploma Supplement refers to the following documents: [...] The following programmes apply to all three types of institutions. Bachelor’s and Master’s study courses may be studied
consecutively, at various higher education institutions, at different types of higher
page
Anlage 3
4.3 Programme Details See “Transcript of Records” for list of courses and grades; and
“Prüfungszeugnis” (final Examination Certificate) for subjects offered in final [...] www.oth-aw.de
On the programme: http://www.oth-aw.de/studium.html
For national information courses c.f.8.8
7. Certification This Diploma Supplement refers to the following documents: [...] The following programmes apply to all three types of institutions. Bachelor’s and Master’s study courses may be studied
consecutively, at various higher education institutions, at different types of higher
receive the best service possible outside of our
business hours. The protection of your data is of course ensured.
** Calls made from German landlines and mobile phones are free of charge for you.
***
in Amberg and Weiden
Preparation course in mathematicsPreparation course in mathematicsPreparation course in mathematicsPreparation course in mathematics
This course aims on one hand to repeat basic skills [...] Amberg-Weiden.
Our university for applied sciences offers high class conditions in nineteen different courses
of study to gain all the knowledge and qualification you will need later on for being
successful [...] and Weiden.
Amberg is home to the department of engineering, and in Weiden, you can study business courses.
Both cities are beautiful, lively centres in the Upper Palatinate region of Bavaria:
Not too
E-Mail: info@oth-aw.de / Internet: http://www.oth-aw.de
Issued 03/2018
Information Sheet
Course of Study
Energy Technology and Energy Efficiency
General Information
This degree programme [...] field of industry, graduates enjoy excellent
career prospects and a high employability rate.
Course of Study
The programme takes seven semesters to complete and
consists of six theoretical semesters [...] programme is divided into modules, which in turn are
combined into module groups according to the course
content. The first module group provides students with the
mathematical and scientific fundamentals